Top of the line 57″ rough cut model with a commercial grade twin cylinder electric start engine and electric clutch blade engagement.Works great behind an ATV; UTV or small tractor for larger acreage jobs.
57″ Rough Cut Mower Features:
57″ Cutting Width
27 HP Briggs & Stratton Commercial Grade Twin Cylinder Engine
Commercial Grade Deck Assembly
4 Tire Design
Quick Two Crank Height Adjust System
Height Adjustment Range From 2″ to 8″
Electric Clutch Blade Engagement
Conservative 2″ Diameter Sapling Rating
Pull Directly Behind or Fully Offset to the Side of the Tow Vehicle.
Specification
Class Mower
Rough Cut (Rear Discharge)
Engine Make
Briggs & Stratton
Engine Model
Commercial Turf OHV (Twin Cylinder with Cyclonic Air Filtration System)
Engine HP
27
Lubrication Method
Pressure with Filter (Low Oil Pressure Shut Off Included)
Electric Start (Battery not included)
Yes
Number of Mower Blades
2-30″
Blade Tip Speed (ft/min)
19;000
Cutting Width
57″
Cutting Height
2.0″ – 8.0″ By Two Cranks
ATV Tongue
Standard (Direct Behind or Full Offset to Either Side)
Blade Engagement Clutch
Electric Clutch (200 ft-lb)
Deck Metal Thickness
10 GA
Deck Top Plate Thickness
Two Separate 1/4 in. Thick Plates
Weight
580 lbs
Pneumatic Front Tires on Casters- Note: Flat Proof Urethance Tire Upgrade Available
15/600×6; 4 Ply Tubeless
Pneumatic Front Tires on Casters – Note: Flat Proof Urethance Tire Upgrade Available
5.30/4.50×6; 4 Ply Tubeless
Fuel Tank Size
3 Gal.
Blade Spindles
Shaft Size
30mm
Bearing
6206-2RST
Drive Method
1 B Section “V” Belt
Warranty
1 Year Commercial (Engine – 3 Year Commercial)
The Wetlands Kit consists of an extra set of tires and mounting brackets
Great for wetlands or marshy areas that stay wet all year around
Works well in combination with small personal amphibious vehicles
Kit more than doubles the tire surface area in contact with the ground
Easy to install
Works on all existing and new rough cut mowers
The rough cut mower will not float with the wetlands kit installed. Water greater than 2-3″ in depth should be avoided.
With the Wetlands Kit installed the minimum cutting height is 3.5″-4″.
The Electric Lift Kit consists of all of the mounting hardware; brackets; electric actuator and wiring with remote control panel.
Great for constantly changing terrain and grass/brush heights
Allows for quick cutting height changes on the go from the seat of the tow vehicle
Raise up and over rocks and logs with ease
Heavy duty 1500 lb linear screw actuator made by Linak
Works on all existing and new rough cut mowers
The Floatation Kit consists of one additional front and rear tire; mounting brackets and hardware
Great for mowing around ponds and on rough uneven ground where scalping would normally occur
Clamping style receiver allows for adjustments from side to side with both the front and rear tires
Pinned receivers make for quick kit removal when not needed
Works on all existing and new rough cut mowers
Warning: This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Need help?
Talk to a real tech
Not sure this is the right part for your build? Our techs ride what they sell — get a straight answer before you order.
