Carbon Fiber Center Console Wrap Cover for Model 3 / Y

Finish availability is generation-specific

Use the exact live combination—not every theoretical pairing exists.

Matte, glossy and forged behave differently in light.

Gloss shows reflections and fingerprints more readily; matte appears quieter; forged uses an irregular flake-like pattern rather than a uniform woven look. Compare option images under similar lighting.

Overlay, not vinyl film

Thin rigid panels add a visible edge and adhesive layer.

The CNC-shaped carbon panels sit over the factory trim. They can reduce direct contact with the original surface and change the cabin look, but they are not invisible and do not make the console scratch-proof.

Function check after dry fit

Open and close every lid, test cupholder access and confirm the intended key-card area while parked. Do not permanently install a panel that catches, rubs or covers a control zone.

Adhesive installation

Surface preparation decides the edge fit.

1. Identify every panelLay out the two- or three-piece set and match all seams before removing adhesive liners.
2. Clean and dryRemove wax, silicone, oils and dust with the supplied wipe; let the surface dry completely.
3. Dry-alignCheck lid gaps, card-slot area, cupholders and equal perimeter spacing.
4. Warm moderatelyInstall in a warm cabin; gently warm adhesive only when necessary—never overheat trim or carbon.
5. Bond from one edgeLower gradually and apply even pressure across the panel, especially the perimeter.
6. Cure undisturbedAvoid cleaners, water and lifting edges during the initial adhesive-set period.

Removal is not automatically damage-free.

Adhesive age, heat and prior surface condition affect removal. Use controlled warmth and plastic tools; residue or finish change is possible.

Installation and real-world context

Use the official sequence, then judge the broader makeover separately.

TESERY installation guide

Panel alignment and bonding

Review the sequence before removing any adhesive liner; match it to the selected console generation.

Third-party showcase

2023 Model Y interior makeover

Useful for visual context; it is not a substitute for the product’s fitment selector or official installation guidance.

Before you order

Center-console cover FAQ

Compare production generation and physical layout: Gen 1 is the earlier three-section glossy console with card slot; Gen 2 is the updated two-section console with card slot; Gen 3 is the Highland/Juniper three-section layout without the same card-slot opening.

The current selector names Model 3 Highland and Model Y Juniper only. Model YL is not stated, so do not assume fitment.

Gen 1 and Gen 2 panels are shaped around the intended card area. Test function while parked after dry fit; exact alignment matters and no universal signal guarantee is made.

You can correct alignment before full bonding more easily than after pressure and cure. Repeated lifting can stretch adhesive, contaminate it or weaken retention.

Confirm generation and finish before exposing adhesive. Installed, scratched or adhesive-contaminated pieces may not qualify; review the current refund policy.

Console architecture → finish → dry alignment

Choose Gen 1, 2 or 3 before choosing carbon appearance.

Choose your console